Wedding box for money or rings

Pin
Send
Share
Send


To create this original box you will need:
• a box from a mobile phone, scissors, a needle and thread;
• a piece of pink satin and double-sided tape;
• the width of the organza ribbon: white - 5 cm, yellow - 4 cm, orange and light green - 2.5 cm each, a piece of tulle;
• width of a floral tape of white and yellow color and a white openwork lace for gifts - 4 cm;
• a thread of small white beads, 3 large beads for pearls, two rings of gold;
• stamens are white and orange.

Initially, it is necessary to make the box itself, and then proceed to decorate it.
So, carefully disassemble the box and lay it on the fabric. Make allowances of 1 cm on all sides and cut.

Using double-sided tape, glue the box with satin (lightly scorch the edges of the fabric to avoid shedding). Sew a fabric joint on a cover from the wrong side with threads to tone. On the front side of the bottom of the box, sew the satin with a hidden seam in the places of its imposition.

Using polymer glue, fasten the floral tape around the perimeter of the box cover (glue the yellow flowers from the tape at the corners, then the white tape). In order to close the junction of the fabric at the end of the box cover, sew a string of beads with a hidden seam.

We begin to make flowers and leaves from organza to decorate the cover.
White flower. You will need 21 cm of white tape with a width of 5 cm. Lay a stitch with six U-shaped bends, leaving a 3 mm allowance on each raw edge.

Evenly distributing the folds, pull the tape and, having formed a flower, fasten the thread.

Twist together 5 pairs of white stamens. Fasten them in the center of the flower.

Yellow flower. Take 21 cm of yellow tape with a width of 4 cm. Lay the line as for the white flower and form the petals. For the middle, twist 3 pairs of white stamens.

Orange flower. You will need an orange ribbon with a width of 2.5 cm and a length of 27 cm. Lay a zigzag stitch and pull the tape tight. Fasten the thread.

Fold in half 3 pairs of orange stamens and sew along the tape assembly line.

At the base of the orange flower, sew 2 pointed leaves with assemblies of light green organza. For each leaflet, use 6 cm tape with a width of 2.5 cm. Then fold the tape as shown in the photo. On both sides, lay 2 folds and sew along the bottom edge.

Make 3 leaves "Sail". For each leaflet, you need to take 13 cm of tape with a width of 2.5 cm, fold in half and bend the corners.

Starting from the corner, lay the stitches along the fold in an oblique line down, then in a straight line and again in an oblique up. Tighten the tape and fasten.

From a piece of light green ribbon and 3 pearl beads, make an open pea pod.

From individual elements (stem, leaves, pod), collect a composition with an orange flower.

Composition "Wedding rings". Cut a circle with a diameter of 4 cm from tulle. In the middle, lightly pick up with a thread. Use glue to fix the rings on the tulle.

Lay out the elements of composition on the box cover. Make notes with a pencil and apply glue to these places. Attach all elements of the composition.

With double-sided tape, attach a patterned white tape 4 cm wide on the sides of the casket.

Pin
Send
Share
Send

Watch the video: Making a wedding rings box (April 2024).